Why is my solder not flowing stained glass?

If you're using the wrong flux or even too much or too little, it can inhibit the solder from melting . Try putting just enough flux that it wets the seams and allows the solder to melt and flow as it should. You want a flux that is strong enough will clean any remaining dirt or oxides without ruining the stained glass.

Why is my solder not flowing?

If you're wondering why it isn't flowing, it could be that you're not using enough heat and are also not heating the metal around the solder join to bring it up to the correct temperature . Consider whether you are using the most suitable torch for the job.

What temperature should I solder stained glass at?

700 degrees is the standard for 60/40 solder, but 600 and 800 degree tips are available.

How to remove too much solder on stained glass?

To do this, hold the piece upside down, then when you touch the soldering iron to where you need it, you should see the solder flow off the piece and onto the iron. Wipe the soldering iron onto the wet sponge to get off the excess solder. Keep repeating this a few times until all the solder is gone from the whole area.

What is the best solder to use for stained glass?

Make sure you have purchased lead meant for stained glass and specifically 60/40 not 50/50. The difference is important. 60/40 is better for stained glass leading in general while 50/50 is better suited for us when it comes to decorative soldering.

Do you have to use flux when soldering stained glass?

Solder needs a flux to flow smoothly and bond to other metals (i.e., copper foil or lead came).

Why is my solder not penetrating?

Solder will not penetrate a joint that is scorched . It won't even adhere to the outside of it. This is the reason I recommend lower flames and slower work. Taking too long won't scorch flux, but too much heat will.

How to get solder to stick to glass?

Solder is a tin/lead alloy with the exception of lead-free solder which is a tin-copper alloy. The higher the ratio of tin to lead, the easier to the solder will flow at lower temperatures. 2. Solder will not stick to glass alone, so each piece of glass must be wrapped in copper foil .

What wattage soldering iron is best for stained glass?

Your iron should have a heat capacity of between 80 and 200 watts . – The exception to this rule is irons with the ceramic heating element, like the Hakko FX-601 above, which is a far more efficient technology and therefore needs less wattage.

Why is my solder not heating up?

Your soldering iron might stop transferring heat correctly because the tip is damaged or oxidized . If the tip has a crack or hole on the plating, then the tip won't heat up all the way and will need to be replaced.

Réparation Triple Vitrage (2024)

1. Réparation de triple vitrage : que faire en cas de fissure ou casse

12 okt 2023 · Entamez par une vérification visuelle pour repérer les fêlures ou les bris. Consignez leur taille et leur emplacement, ce qui vous facilitera l' ...
S’équiper de triple vitrage évoque généralement une sensation de sérénité et de bien-être. En intégrant un troisième élément de verre, ce genre de vitrage offre un point fort en matière d’isolation, aussi bien sur le plan thermique que sonore, comparativement à son hom*ologue, le double vitrage. Néanmoins, en tant que matériel, le verre n’est pas […]

Réparation Triple Vitrage (2024)

FAQs

References